These CNC-machined, high-strength aluminum handlebar risers are extremely robust thanks to their special screw fastening (from below) on the triple clamp. Twisting and bending are therefore practically impossible. Use of these handlebar risers is only possible on CNC-machined triple clamps. Available in three different heights.

Extremely robust spark plug
Center electrode tip made of iridium
Reinforced ground electrode
Special design for better ignition and performance
Copper gasket for improved heat dissipation

CNC milled from high-strength aluminum
Elegant anodised surface
Prevents the hand grips from chafing in the event of a fall

Protects the footpegs from damage during a potential fall

For use with stock foot pegs.

Friction optimized components
Adjustable spring preload
Adjustable rebound damping
Adjustable compression damping
Closed cartridge technology
Fully adjustable with standard tools
Unique valve system
Better response
Consistent performance
Improved damping behavior
Improved and calmer ride
Improved handling

Scope of delivery

Spring fork with 7.0 N/mm fork spring
Sticker
Tools
Notes

Fork length: 912mm
Stroke: 240mm

When mounting on KTM 790/890 Adventure brake hose 63542103000 and side stand 63503423000C1 are also required. When mounting on Husqvarna Norden 901 side stand 63503423000C1 is required.

Secure stand for your bike
Facilitates chain maintenance

Perfect protection for your radiator
Provides maximum protection at the lowest possible weight
Perfectly integrated into the motorcycle
Perfect fit
High-quality look
Optimal protection against stone impact

CNC milled from high-strength aluminum
Elegant anodised surface

High-quality look
Integrate perfectly into the vehicle design
Modern and simple design
Visual highlight
Plug & Play mounting
Increased safety due to extremely bright flashing light

Small design: width approx. 20 mm, length approx. 73 mm
Contains 4 LED turn signals: 2 pcs. for the front and 2 pcs. with integrated rear and brake light for the rear

Recommended article: License plate holder support (A60708915044)

Universally applicable for mounting the GPS bracket

More torqueIncreased performance
More usable speed range
Better power delivery
Improved handling overall due to finer dosing capacity on the throttle grip
Sensitive response
Rich sound
Manifold routing optimally adapted to the production engine
Stainless steel header
Silencer housing made of high-grade titanium
Complies with current AMA noise regulations
Factory Racing Team look

This system offers a weight saving of 16,7 % (0.6 kg) over the stock exhaust.
Gasgas: To install the silencer, the stock mounting parts must be overtaken.
ATTENTION: When used on EU models from MY26 and US models from MY26 FACTORY EDITION / MY27 Standard, the air box and air filter must be reverted to MY25. The correct engine mapping must also be installed. Vehicles in this configuration no longer comply with the 109 dB FIM noise limit.

Closed design
2-component plastic handguard
Black middle section = maximum strength for optimum protection
Colored top and bottom parts = highly flexible under the roughest conditions
Available in two different heights
Improved optics

High version

Optimal protection against penetration of mud, sand and water into the wheel bearing of your wheel
Reduces wear on sealing rings and wheel bearings for longer service life
Wheel bearing repair kit with wheel bearing protection cap set and low friction shaft sealing rings.

Perfectly adapted to the KTM ADVENTURE family
Developed together with the vehicle
Disassembly/assembly in seconds
The ergonomic handle disappears completely into the case
The floating topcase carrier prevents the vehicle from swinging at high speeds

Materials: plastic and aluminum
Dimensions: 505 mm x 345 mm x 385 mm
Maximum load: 5 kg

Extra strong sheet steel
Nickel-plated surface
Full sound
Better power delivery

Combination with FMF silencer recommended

Protects the water pump cover
Protects the radiator hoses at the hose connection