Recommended for extremely dusty conditions
Acts as an additional protective layer
Extends the filter service intervals
Premature sanding of the air filter is avoided

Color differences between the upper and lower triple clamp cannot be technically ruled out.

CNC milled aluminum triple clamp
Elegant anodised surface
Optimally tuned steering stem stiffness
100% alignment of the fork tubes
Ideal flexibility – precisely customised to the WP fork
Specially optimised geometry of the fork clamping
No ovalization of the fork outer tube
Highly precise and smooth fork response
Maximum handling gain
Gain in stability at the front wheel
Overall, more homogeneous force flows in the entire vehicle
Simple offset adjustment
Including steering stem with steering head bearing already pressed on
Very simple offset adjustment of 20 or 22 mm
Shorter offset: Stability on fast straights
Longer offset: easier and quicker cornering in curves

Optimal protection against penetration of mud, sand and water into the wheel bearing of your wheel
Reduces wear on sealing rings and wheel bearings for longer service life
Wheel bearing repair kit with wheel bearing protection cap set and low friction shaft sealing rings.

CNC milled handlebar mount with damping rubber inserts
Gentle on wrists and shoulder joints
Damping of hard shocks
Absorption of chassis and engine vibrations
Additional handlebar damping in horizontal direction
Optimum steering precision

Provides maximum protection at the lowest possible weight
Optimal protection against stone impact
Easy to mount

Warm hands, no matter what the weather
Grip temperature adjustable in 4 steps
Operation using the menu switch on the handlebar

CNC milled from high-strength aluminum
Elegant anodised surface

Specifically for soft surfaces such as sand
Secure stand for your bike

Enlarged surface for the gear selector on the left combination switch

Control unit for adjusting the heated seat and heated grips through the combination switches and the dashboard.

WIRING HARNESS FOR SEAT HEATING (A62611986000) - Required

KTM ERGO RIDER'S SEAT - Required
(A62607940016C1A) same height
(A62607940018C1A) Higher
(A62607940014C1A) Lower

Extremely light
Made of high-quality carbon
Highest quality workmanship
Perfect for changing the look of your motorcycle
Silk matte surface

CNC milled from high-strength aluminum
Elegant anodised surface
Extremely light
Visual highlight with technical and ergonomic added value
Perfect for use on the race track
Adjustable grip width
Flaps removed on ground contact
Prevents broken levers

High stiffness and strengthProtects against heat and unwanted contactExtremely lightExtremely durableLow thermal expansionHigh long-term temperature stabilityMaximum protection against falls, flying stones, branches, etc.

CNC milled from high-strength aluminum
Resistant to the toughest stresses and strains
Weight-optimised

Specifically suited to extreme conditions: for more air, better cooling and maximum power. Indispensable not only at the Erzberg or the Extreme Lumezzane.

Silencer housing made of high-grade aluminum
Stainless steel silencer cap
Rich sound
Permanently welded brackets
Easy to mount
Reduced weight

For a system with optimized performance and perfect balance we recommend the combination with the FMF Fatty expansion chamber.